Using A Kensington Security Cable; Connect The E-Msm720 To A Power Source - HP E-MSM720 Installation Manual

C a u t i o n
Attach the rubber feet to the four corners on the bottom of the E-MSM720
within the embossed angled lines. Use a sturdy surface in an uncluttered area.
You may want to secure the networking cables and E-MSM720 power cord to
the table leg or other part of the surface structure to help prevent tripping over
the cords.
Ensure the air flow is not restricted around the sides and back of the E-
MSM720.

Using a Kensington Security Cable

To prevent unauthorized removal of the E-MSM720, you can use a Kensington
Slim MicroSaver security cable (not included) to attach the E-MSM720 to an
immovable object.
Figure 2-6. Using a Security Cable

4. Connect the E-MSM720 to a Power Source

1. Plug the AC/DC adapter's power cord into the E-MSM720, and then plug
the AC/DC power adapter into a nearby AC power source.
2. Re-check the LEDs during self test. See
3. For the E-MSM720, use the included cable tie to secure the power cord to
the E-MSM720.
Installing the E-MSM720
Installation Procedures
"LED Behavior" on page 2-5.
2-9