Table of Contents
Advertisement
User Manual
User Manual of 87XX-P Series NVR
5.9 Configuring HDD Group for Recording
Purpose:
You can group the HDDs and save the record files in certain HDD group.
Steps:
1.
2.
Check whether the storage mode of the HDD is Group. If not, set it to Group. For detailed information,
please refer to Chapter 12.4 Managing HDD Group.
3.
4.
Repeat the above steps to configure more HDD groups.
5.
Enter HDD setting interface.
Menu>HDD
Select Advanced on the left bar.
Select General in the left bar.
Click
to enter editing interface.
Configuring HDD group.
1)
Choose a group number for the HDD group.
2)
Click Apply and then in the pop-up message box, click Yes to save your settings.
3)
Click OK to back to the upper level menu.
Choose the Channels which you want to save the record files in the HDD group.
1)
Select Advanced on the left bar.
2)
Choose Group number in the dropdown list of Record on HDD Group
3)
Check the channels you want to save in this group.
4)
Click Apply to save settings.
Note:
After having configured the HDD groups, you can configure the recording settings following
the procedure provided in Chapter 5.2-5.7.
Figure 5. 36 HDD General
Figure 5. 37 Storage Mode
73
Advertisement
Table of Contents
