OVS 4CH-P4 Quick Operation Manual page 234

8700-p series
Table of Contents

Advertisement

User Manual
User Manual of 87XX-P Series NVR
Live view stuck when video output remotely via the Internet Explorer or platform software.
Possible Reasons:
a) Poor network between NVR and IPC, and there exists packet loss during the transmission.
b)Poor network between NVR and PC, and there exists packet loss during the transmission.
c) The performances of hardware are not good enough, including CPU, memory, etc..
Steps:
1. Verify the network between NVR and IPC is connected.
1)
2)
Note:
Simultaneously press Ctrl and C to exit the ping command.
2. Verify the network between NVR and PC is connected.
1)
2)
3. Verify the hardware of the PC is good enough.
Simultaneously press Ctrl, Alt and Delete to enter the windows task management interface, as shown in the
following figure.
4. Check if the fault is solved by the above steps.
If it is solved, finish the process.
If not, please contact the engineer to do the further process.
When using the NVR to get the live view audio, there is no sound or there is too much noise, or the volume
is too low.
Possible Reasons:
a) Cable between the pickup and IPC is not connected well; impedance mismatches or incompatible.
When image is stuck, connect the RS-232 ports on PC and the rear panel of NVR with the RS-232 cable.
Open the Super Terminal, and execute the command of "ping 192.168.0.0 –l 1472 –f" (the IP address
may change according to the real condition), and check if there exists packet loss.
Open the cmd window in the Start menu, or you can press "windows+R" shortcut key to open it.
Use the ping command to send large packet to the NVR, execute the command of "ping 192.168.0.0 –l
1472 –f" (the IP address may change according to the real condition), and check if there exists packet
loss.
Note:
Simultaneously press Ctrl and C to exit the ping command.
Windows task management interface
Select the "Performance" tab; check the status of the CPU and Memory.
If the resource is not enough, please end some unnecessary processes.
211

Advertisement

Table of Contents
loading

This manual is also suitable for:

8ch-p48ch-p816ch-p8

Table of Contents