Table of Contents
Advertisement
User Manual
User Manual of 87XX-P Series NVR
If you want to enable the UPnP™ function of the device, you must enable the UPnP™ function of the router to
which your device is connected. When the network working mode of the device is set as multi-address, the
Default Route of the device should be in the same network segment as that of the LAN IP address of the router.
Steps:
1. Enter the Network Settings interface.
Menu > Configuration > Network
2. Select the NAT tab to enter the port mapping interface.
3. Check
4. Select the Mapping Type as Manual or Auto in the drop-down list.
OPTION 1: Auto
If you select Auto, the Port Mapping items are read-only, and the external ports are set by the router
automatically.
Steps:
1)
2)
3)
OPTION 2: Manual
If you select Manual as the mapping type, you can edit the external port on your demand by clicking
activate the External Port Settings dialog box.
Steps:
1)
2)
Figure 11. 33 UPnP™ Settings Interface
checkbox to enable UPnP™.
Select Auto in the drop-down list of Mapping Type.
Click Apply button to save the settings.
You can click Refresh button to get the latest status of the port mapping.
Figure 11. 34 UPnP™ Settings Finished-Auto
Select Manual in the drop-down list of Mapping Type.
Click
to activate the External Port Settings dialog box. Configure the external port No. for server
port, http port, RTSP port and https port respectively.
1) You can use the default port No., or change it according to actual requirements.
154
to
Advertisement
Table of Contents
