Table of Contents
Advertisement
User Manual
User Manual of 87XX-P Series NVR
5.1 Configuring Encoding Parameters
Purpose:
By configuring the encoding parameters you can define the parameters which affect the image quality, such as
the transmission stream type, the resolution and so on.
Before you start:
1. Make sure that the HDD has already been installed. If not, please install a HDD and initialize it.
(Menu>HDD>General)
2. Check the storage mode of the HDD
Steps:
1. Enter the Record settings interface to configure the encoding parameters:
Menu>Record>Encoding
2. Encoding Parameters Setting for Recording
1)
Figure 5. 1 HDD- General
1) Click Advanced to check the storage mode of the HDD.
2) If the HDD mode is Quota, please set the maximum record capacity and maximum picture
capacity. For detailed information, see Chapter Configuring Quota Mode.
3) If the HDD mode is Group, you should set the HDD group. For detailed information, see Chapter
Configuring HDD Group for Recording.
Figure 5. 2 HDD- Advanced
Figure 5. 3 Record Parameters
Select Record tab page to configure. You can configure the stream type, the resolution, and other
parameters on your demand.
54
Advertisement
Table of Contents
