Configuration Using User Programs - Panasonic FP7 User Manual

MEWNET-W2

5.3.6 Configuration Using User Programs

In MEWNET-W2, unit numbers can be set by the user programs (PMSET/pPMSET
instruction). The unit number selector on the front panel of the unit needs to be set to 00.
 Sample program
This sample program shows the case that the unit number for the FP7 MW Unit (W2 link unit)
in the slot number 1 is set to 10.
R100
R101
KEY POINTS
• For the MEWNET-W2, the link area cannot be allocated by the user
programs. Allocate the area in the "W2 Link Unit Settings" dialog box of the
tool software.
5-10
MV.US
UNITSEL
pPMSET DT100
S1
Unit number setting
U10 DT100
DT100: Unit no. (U10)
S D
Communication port settings
S1: Slot no. (U1)
U1 U0
S2: Port no. (U0)
S1 S2
Communication parameter settings
S1: Communication parameter
U1 DT200
setting area (DT100)
n D1
D1: Processing result storage
destination (DT200)
n: No. of set words (U1)