Configuration Using User Programs - Panasonic FP7 User Manual

MEWNET-W

4.3.6 Configuration Using User Programs

In MEWNET-W, unit numbers, link relays and link registers can be allocated by the user
programs (PMSET/pPMSET instruction). The unit number selector on the front panel of the
unit needs to be set to 00.
 Sample program
This sample program shows the allocation of unit number, link relay and link register for the
FP7 MW Unit (W Link Unit) installed in the slot number 1.
R100
R101
4-10
MV.US
MV.US
MV.US
MV.US
MV.US
MV.US
MV.US
MV.US
MV.US
MV.US
UNITSEL
pPMSET DT0
S1
U10 DT100
S D
U50 DT101
S D
U100 DT102
S D
U0 DT103
S D
U64 DT104
S D
U128 DT105
S D
U10 DT106
S D
U20 DT107
S D
U40 DT108
S D
U40 DT109
S D
Communication port settings
U1 U0
S1: Slot no. (U1)
S2: Port no. (U0)
S1 S2
MW communication parameter settings
U10 DT100
S1: Communication parameter
n D1
D1: Processing result storage
PLC link parameter settings
DT100: Unit no. (U10)
DT101: Link relay holding start
relative address (U50)
DT102: Link register holding
start relative address (U100)
DT103: Memory block no.
(WL0-63,LD=0-127) (U0)
DT104: Link relay range (U64)
DT105: Link register range
(U128)
DT106: Link relay transmission
start no. (U10)
DT107: Link relay transmission
size (U20)
DT108: Link register transmission
start no. (U40)
DT109: Link register transmission
size (U40)
setting area (DT0）
n: No. of set words (U10)
destination (DT100)