Setting The Switches Of The Unit - Panasonic FP7 User Manual

4.2 Setting the Switches of the Unit

For using the FP7 MW Unit as W link unit, the switches on the front of the unit need to be set.
 Mode selector switches
Each mode is set with the four dip switches on the front of the unit.
1
2
3
4
ON OFF
No. Item
Operation
1
mode
2
Mode
3
4 Baud rate
(Note 1): All the switches are set to OFF at the factory.
(Note 2): Be sure the power is off when changing the switches.
 Unit number selector
Specify the own unit number by the two rotary switches on the front of the unit.
UNIT
NO.
Range Description
01 to 16 For target unit of PLC link
01 to 32 For target unit of data transfer
When setting it in the configuration of the tool software or user program (PMSET/pPMSET
00
instruction).
(Note 1): Be sure the power is off when changing the switches.
Range
OFF: PLC link mode, ON: Non-PLC link mode
Turn off the both 2 and 3 to activate the unit as the unit for "MEWNET-W".
For "MEWNET-W", iit is fixed at 500 kbps.
4.2 Setting the Switches of the Unit
4-3