Pmset/Ppmset Instruction (For Mewnet-W2) - Panasonic FP7 User Manual

Instruction References

9.1.7 PMSET/pPMSET instruction (For MEWNET-W2)

Unit numbers can be set.
 Instruction format
R100
(Note): The above figure shows the case that the FP7 MW Unit of S1=U1 (slot no.1) is specified by UNITSEL
instruction.
 Operand
Item Settings
Specify the starting address of the device storing set
S
communication parameters.
n Specify the number of set words.
Specify the device area of the local unit storing the
D
processing result (1 word).
(Note 1): For MEWNET-W2, specify 1.
 [S]: Communication parameter settings in W2 mode
Parameter
[S] Unit No.
 [D]: Processing result
• The execution result is stored in the area of one word.
• The execution result code in the lower byte is valid when the processing flag of bit 15 is zero.
bit no. 15
Processing flag
0: Processing completed
1: Processing in progress
Execution result flag
0: Normal end
1: Abnormal end
9-14
UNITSEL
PMSET DT0
S
Range Description
It can be changed only when the rotary switch on the front
U1 to U64
panel of the unit is set to 0.
8 7
0 0 0 0 0 0
Execution result code
0: Normal end
1: Communication port specified by UNITSEL instruction
2: Setting error
3: Mode change error
4: Communication port being used
5: Change request parameter mismatch (Parameters
7: When the unit number selector on the MW Unit is not 0.
U1 U0
S1 S2
U1 DT100
n D
Settable device
WX,WY,WR,WL,DT,LD
WX,WY,WR,WL,DT,LD,
U
WX,WY,WR,WL,DT,LD
0
is incorrect.
specified by operand are different when the setting
process starts and ends.)
Setting range
U1 (Note 1)