Setting The Inter-Unit Control Wiring Connection On/Off; Other Settings - Panasonic CZ-256ESMC3 Technical Data Manual

Installation Instructions

(3) Setting the inter-unit control wiring connection on/off

1 Repeat steps 1 to 3 in section (2) "Adaptor number setting procedure" above. The following will display:
2 Press the key once so the following display appears:
UP
3 Hold down the key for at least 1 second so the "0" part blinks, indicating that the setting can be changed. (The green and red monitor
SET
LEDs are both on.)
Use the and keys to turn the inter-unit control wiring connection on or off as shown in the table below.
DOWN
UP
Setting value Inter-unit control wiring connection
0 LINK1: On, LINK2: On (factory setting)
1 LINK1: On, LINK2: Off
2 LINK1: Off, LINK2: On
3 LINK1: Off, LINK2: Off
For example, to connect the inter-unit control wiring only to LINK1, press the
4 Press the key for at least 1 second to confirm. (Only the green monitor LED is on.)
SET

(4) Other settings

With the display status showing as in number
the setting items shown in the table below. Set as needed.
The setting procedure is the same as above.
(Press the key for at least 1 second, press the
SET
Note
1 When configuring, do not set the same adaptor number more than once.
* Use numbers between 1 and 7 for connecting to an Intelligent Controller.
2 Turn the inter-unit control wiring connection on/off as appropriate.
(Set to "Off" for LINKs with no connection.)
3 For connecting the inter-unit control wiring to only one link, use the
"LINK1" side.
(1.Ano.03) (When the adaptor number is 3)
(2.Adyu.0) (Factory setting)
(2.AdYu.1)
in section (2) "Adaptor number setting procedure", press the
3
and
UP DOWN
ー 158 ー
Communication adaptor
key once. The following display will result:
UP
keys to change, then press the
SET
5
and keys to select
UP DOWN
key at least one second to confirm.)