Tie-Rod And Bevel Gear Case Assembly; Separation Of Bi-Speed Turn Case - Kubota B2410 Workshop Manual

B241 0 • B2710 • B2910 WSM, 12271
6 FRONT AXLE
(2) Disassembling Front Axle Assembly
Tie-rod and Bevel Gear Case Assembly
1. Remove the bi-speed turn rod (1).
2. Remove the slotted nut and disconnect the tie-rod (2) from the
front gear case (3).
3. Remove the bevel gear case (4) and front gear case (3) as a unit
from the front axle case (5).
(When reassembling)
• Apply grease to the a-ring and take care not to damage it.
• Do not interchange right and left bevel gear case assemblies.
• After tightening the slotted nut to the specified torque, install the
cotter pin as shown in the figure.
Bevel gear case mounting
123.5 to 147.0 N·m
Tightening torque 12.6 to 15.0 kgf·m
screw
91.2 to 108.4 ft-Ibs
11790F60050
(1) Bi-speed Turn Rod
(2) Tie-rod
(3) Front Gear Case
(4) Bevel Gear Case
(5) Front Axle Case
12271860230
Separation of Bi-speed Turn Case
1. Remove the bi-speed turn case mounting screws and separate
the bi-speed turn case (1) from the bi-speed turn gear case (2).
(When reassembling)
• Apply liquid gasket (Three Bond 1208D or equivalent) to joint
face of the bi-speed turn case (1) and bi-speed turn gear case.
• Install the bi-speed turn case to the bi-speed turn gear case,
noting the position of shifter collar. (Place the shifter collar
between shift fork and shifter)
• After shifting the bi-speed turn shifter to the spiral bevel pinion
shaft side, mount the shift fork on the shifter and install the case
to the gear case.
Bi-speed turn case
23.6 to 27.4 N·m
Tightening torque
2.4 to 2.8 kgf·m
mounting screw
17.4 to 20.2 ft-Ibs
(1) Bi-speed Turn Case
(2) Bi-speed Turn Gear Case
12271860240
6-819