Brake Pedal; Adjusting Brake Pedal Free Travel; Tightening Torques - Kubota B2410 Workshop Manual

58RAKES
TIGHTENING TORQUES
B2410 • B2710 • B2910 WSM, 12271
Tightening torques of screws, bolts and nuts on the table below are especially specified.
(For general use screws, bolts and nuts: See page G-9.)
Item N·m kgf·m ft-Ibs
(82410)
Rear wheel hub mounting nut
108 to 125
11.0t012.8 80 to 93
Cotter setting bolt and nut
123 to 147
12.6 to 15.0 91 to 108
Rear axle case mounting screw
29.2 to 44.1
4.0 to 4.5 28.9 to 32.5
(82710,82910)
Rear wheel mounting screw and nut
108 to 125
11.0 to 12.8 80 to 93
Rear axle case mounting screw
39.2 to 44.1 4.0 to 4.5 28.9 to 32.5
12271840020
CHECKING, DISASSEMBLING AND SERVICING
CHECKING, ADJUSTING AND SERVICING
[1] BRAKE PEDAL
12010F50030
Adjusting Brake Pedal Free Travel
A
CAUTION
• Stop the engine and chock the wheels before checking
brake pedal.
• The difference between the right and left pedal plays must
be less than 4.0 mm (0.16 in.).
1. Release the parking brake.
2. Slightly depress the brake pedals and measure free travel at top
of pedal stroke.
3. If the measurement is not within the factory specifications,
loosen the lock nut and turn the turnbuckle to adjust the brake
rod length.
4. Retighten the lock nut securely.
Keep the free travel in the right and left brake pedals equal.
Brake pedal free travel Factory spec.
30 to 40 mm
1.18to 1.57 in.
• NOTE
• After checking brake pedal free play, be sure to engage the
parking brake lever fully and check to see that the brake
pedals are securely locked.
(1) Brake Pedal (3) Lock Nut
(2) Turnbuckle
12490850030
5-S2