Cruise Control Linkage; Adjusting Cruise Control Linkage; Adjusting Cruise Control Release Linkage; Cruise Control Lever - Kubota B2410 Workshop Manual

3 TRANSMISSION
Cruise Control Linkage
12271F30110
12271F30130
82410 • 82710 • 82910 WSM, 12271
(1) Grip
(2) Cruise Control Lever
(3) Lever Pin
(4) Cruise Control Arm
(5) Cruise Control Rod
(6) HST Pedal
(7) HST Pedal Lever
(8) HST Release Rod
(9) Release Lever 1
(10) Release Lever 2
(11) Release Arm
(12) Nut
• Adjusting Cruise Control Linkage
With the cruise control lever (2) at the N position on the lever
guide, check for a gap between the lever pin (3) and the cruise
control arm (4). Adjust the cruise control rod (5), when required, to
leave no gap between them.
At the same time, make sure that there is no gap between the
rear end of the oval hole of the HST pedal lever (7) and the pin of
the HST pedal (6).
Finally step down the HST pedal (6) all the way to make sure
that the cruise control lever (2) can hold the HST pedal in place.
• Adjusting Cruise Control Release Linkage
Adjust the brake pedals play first. Then adjust the HST release
rod (8) turnbuckle to allow no gap between the release levers 1 (9)
and 2 (10) as well as between the release lever 2 (10) and the
release rod (11).
Now step on one of the brake pedals to make sure the cruise
control is not released. Also step on both the brake pedals coupled
together to make sure that the cruise control is released.
• Cruise Control Lever
1. After adjusting the cruise control linkage, measure the force to
move the cruise control lever (2) forward at its top (grip).
2. If the force is not within the factory specifications, loosen the lock
nut and turn the nut (12) to adjust.
3. Retighten the lock nut securely.
49.0 to 58.8 N
Force to move the lever Factory spec. 5.0 to 6.0 kgf
11.0 to 13.2 Ibs
• IMPORTANT
• After adjusting the linkage, be sure that the cruise control
lever (2) can be held anywhere within its working range.
12271830020
3-S8