Separating Clutch Assembly; 2-S8 - Kubota B2410 Workshop Manual

2 CLUTCH
B2410· B2710· B2910 WSM, 12271
Separating the Engine from Clutch Housing
1. Disconnect the three point hitch delivery pipe and suction hose.
2. Disconnect the glow plug lead wire and thermo sensor lead wire.
And then disconnect the connector for dynamo and starter motor
lead wire.
3. Place the jack under the center frame.
4. Hoist the engine by the chain at the engine hook.
q.
Remove the engine mounting ,screws and separate the engine
from the clutch housing.
(When reassembling)
• Apply liquid gasket (Three Bond 1208D or equivalent) to joint
face of the engine and clutch housing.
17.7 to 20.6 N·m
Engine mounting M8 screw 1.8 to 2.1 kgf·m
13.0 to 15.2 ft-Ibs
Tightening torque
48.1 to 55.8 N·m
Engine mounting M10 nut 4.9 to 5.7 kgf·m
35.5 to 41.2 ft-Ibs
12270810180
23.5 to 27.5 N·m
Tightening torque Clutch mounting screw 2.4 to 2.8 kgf·m
17.4 to 20.2 ft-Ibs
12010820110
(3) Clutch Cover (1) Clutch Disc
(2) Clutch Assembly
[2] SEPARATING CLUTCH ASSEMBLY
Separating the Clutch Assembly
1. Remove the clutch assembly (2) from the flywheel.
(When reassembling)
• Direct the shorter end of the clutch disc boss toward the
flywheel.
• Apply molybdenum disulphide (Three Bond 1901 or equivalent)
to the splines of clutch disc boss.
• Install the pressure plate, noting the position of straight pins.
• IMPORTANT
• Align the center of clutch disc and flywheel by inserting the
clutch center tool.
• NOTE
• Do not allow grease and oil on the clutch disc facing.
Clutch Rod and Clutch Release Fork
1. Remove the clutch pedal rod.
2. Remove the external snap ring at the end of clutch rod (1) and
remove the clutch release fork (2) and release bearing (3) with
release hub.
(When reassembling)
• Set the clutch release fork and release hub with set spring (4) in
the correct direction.
(1) Clutch Rod
(2) Clutch Release Fork
(3) Release Bearing
(4) Set Spring
12270820050
2-S8