Propeller Shaft; Front Axle - Kubota B2410 Workshop Manual

6 FRONT AXLE
82410 • 82710 • 82910 WSM, 12271
Propeller Shaft
1. Loosen the clamp (4) and slide the propeller shaft cover (1) to
the rear.
2. Tap out the spring pin (2), and then slide the coupling (3) to the
rear.
(When reassembling)
• Apply grease to the splines of the propeller shaft.
(1) Propeller Shaft Cover
(2) Spring Pin
(3) Coupling
(4) Clamp
12271860200
12271F60210
11790F60050
S008177P334
Drag Link
1. Steer the front wheels to the left.
2. Remove the slotted nut and disconnect the drag link from the
knuckle arm .
• IMPORTANT
• After tightening the slotted nut to the specified torque,
install the cotter pin as shown in the figure left.
17.7 to 34.3 N·m
Tightening torque Slotted nut 1.8 to 3.5 kgf·m
13.0 to 25.3 ft-Ibs
12271860210
Front Axle
1. Place the jack under the clutch housing.
2. Place the jack under the front axle.
3. Remove the front wheels.
4. Remove the front axle brackets (Front and Rear) mounting
screws.
5. Separate the front axle from the front axle frame.
Front axle bracket
124 to 147 N·m
mounting screws
12.6 to 15.0 kgf·m
91.1 to 108.5 ft-Ibs
Tightening torque
77.5 to 90.2 N·m
Front wheel mounting
7.9 to 9.2 kgf·m
screws
57.1 to 66.5 ft-Ibs
12271860220
6-S18