Replacing Hydraulic Oil Filter Cartridge; Cleaning Transmission Oil Strainer - Kubota B2410 Workshop Manual

G GENERAL
82410· 82710· 82910 WSM, 12271
Replacing Hydraulic Oil Filter Cartridge
A
CAUTION
• Be sure to stop the engine before changing the oil filters.
1. Drain the transmission fluid.
2. Remove the oil filter cartridge by using a filter wrench.
3. Apply a slight coat of oil onto the cartridge gasket.
4. To install the new cartridge, screw it in by hand. Over tightening
may cause deformation of rubber gasket.
5. After the new cartridge has been replaced, the transmission fluid
level will normally decrease slightly. Make sure that the
transmission fluid does not leak through the seal. Check the
fluid level.
• IMPORTANT
• To prevent serious damage to the hydraulic system. Use
only a genuine KUBOTA filter or its equivalents.
(1) Hydraulic Oil Filter (for HST) (2) Hydraulic Oil Filter
12490G00090
12490F00140
Cleaning Transmission Oil Strainer
1. Clean the strainer with nonflammable solvent.
• NOTE
• When changing the transmission fluid, disassemble and
rinse the strainer with nonflammable solvent to completely
clean off fillings.
When reassembling, be careful not to damage the parts.
• Since the fine fillings in the oil could impair the component
parts of the hydraulic system precision built to withstand
high pressure, the suction line end is provided with an oil
strainer.
• Please do the replacing oil filter cartridge (3) and the
cleaning oil strainer (1) at the same time. And when
replacing, reinstall the oil strainer first.
(1) Strainer (3) Hydraulic Oil Filter Cartridge
(2) a-ring
12271 G00070
G-14