Battery - Kubota B2410 Workshop Manual

82410 • 82710 • 82910 WSM, 12271
G GENERAL
• Clamp wIring so that there is no twist, unnecessary sag, or
excessive tension, except for movable part, where sag be
required.
(A)
(B)
(1)
Wiring
(2) Clamp
(A) Correct
(B) Incorrect
11790F00120
(A)
11790F00130
11790F00140
(2) Battery
11790GOO 100
• In installing a part, take care not to get wiring caught by it.
(1) Wiring (A) Incorrect
11790G00110
• After installing wiring, check protection of terminals and clamped
condition of wiring, only connect battery.
(1) Cover
• Securely Install Cover
11790GOO 120
11790F00060
• Take care not to confuse positive and negative terminal posts.
• When removing battery cables, disconnect negative cable first.
When installing battery cables, check for polarity and connect
positive cable first.
• Do not install any battery with capacity other than is specified
(Ah).
• After connecting cables to battery terminal posts, apply high
temperature grease to them and securely install terminal covers
on them.
• Do not allow dirt and dust to collect on battery.
A
CAUTION
• Take care not to let battery liquid spill on your skin and
clothes. If contaminated, wash it off with water immediately.
• Before recharging the battery, remove it from the machine.
• Before recharging, remove cell caps.
• Do recharging in a well-ventilated place where there is no
open flame nearby, as hydrogen gas and oxygen are
formed.
11790G00131
G-5