Quick Start Guide - FLIR AX8 User Manual

Quick start guide

Follow this procedure:
1. Mount the camera.
CAUTION
The camera must be mounted on a cooling bracket or heat sink unless the rear side of the camera
is mounted against a material with a high capacity to transfer heat, e.g., aluminum. Damage to the
camera can occur if you do not do this.
2. Download FLIR IP Config
3. Install FLIR IP Config.
4. Connect the camera to power, either via a PoE injector connected to the Ethernet
ca-ble or via the power–I/O connector (10.8–30 V DC).
5. Connect the camera to the network, using the Ethernet connector.
6. Start FLIR IP Config.
7. In the main window, identify the camera and double-click it to open the camera user
web.
8. Log in using the username admin and the password admin. (You can change these
credentials later.)
You have now accessed the FLIR AX series user web and can set up and control the
camera.