FLIR AX8 Quick Start Manual

55 mm (2.17 in)
LED
Camera
IR
13.5 mm
(0.53 in)
Ethernet and PoE
25.6 mm (1.00 in)
Reset
Ethernet
Diagnostics LED
Power
Diagnostic LED
7 mm
(0.28 in) 60 mm (2.36 in)
12 mm 5 mm
(0.47 in) (0.20 in)
Quick Start Guide
Document number: 88050-3-EN
Date: 09-2015
Connections to a Raymarine MFD
The AX8 can be powered using the supplied PoE injector,
alternatively, it can also be powered by a Raymarine MFD /
network switch capable of providing power over ethernet (PoE).
Raymarine LightHouse MFD
14 mm
(0.55 in)
Raymarine LightHouse MFD with PoE
Class 2
PoE device
Set-up
The AX8's built-in web interface MUST be used to align the thermal and visible images before using
®
Thermal MSX mode and to set-up spot alarms. The web interface also provides access to other
features and settings not available on your MFD.
Connect the AX8 to your MFD
1
network and ensure it is powered.
12 V / 24 V dc
Class 2
PoE device
3
Connect your PC or smart
Powered by
device to the MFD network.
PoE injector
For information on connecting a
PC or smart device to your
Raymarine MFD network,
refer to the LightHouse
Operation instructions
(81360).
5
®
When using the camera in Thermal MSX mode,
you can use the "Adjust Distance" slider control in
the web interface to adjust the overlay position of
the visible Vs. the thermal image.
Powered by PoE injector
12 V / 24 V dc
Class 2
PoE device
12 V / 24 V dc
Potential ignition
source
The PoE injector is NOT
approved for use in hazardous/
flammable atmospheres. Do
NOT install in a hazardous/
flammable atmosphere (such as
in an engine room or near fuel
tanks). In this scenario, you can
use a female to male RJ45
adapter cable (available separately)
to extend the cable run between
the AX8 and the PoE injector.
Refer to the FLIR AX Series user
manual (T559913), available on the
supplied CD for full details of the
features and settings available
from the web interface.
Raymarine LightHouse MFD
2
Obtain the AX8's IP address, this can be found
by accessing the AX8's diagnostics page using
a Raymarine LightHouse MFD.
Homescreen > Set-up > Maintenance >
Diagnostics > Select Device > AX8.
Scroll down to Networks, the IP address is
Wi-Fi
part of the RTSP URL.
PC / Smartphone / tablet
6
Select the Spot alarm icon
to add a new spot to the
image, drag the spot to the
required position and then
set the temperature alarm
by selecting the bell icon.
Up to 8 AX8 cameras can be networked together.
Raymarine LightHouse MFD
12 V / 24 V dc
rtsp://10.22.0.32/avc
4 Enter the AX8's IP address in the web browser's
address bar on your conntected PC or smart device.
Default logon:
Username: admin
Password: admin
Alternatively you can connect the AX8 directly to a
PC using an ethernet (RJ45) cable.
To obtain the AX8's IP address using a PC download
and install the FLIR IP Config tool version 1.9 or greater.
Max.
x8
12 V / 24 V dc 12 V / 24 V dc