Verifying camera operation
Prior to installing the camera, use a bench test to verify camera operation and to config-
ure the camera for the local network. The camera is configured from a web browser.
12.1 Connecting the camera to power
To power the camera, use one of the alternatives below:
• Connect the camera to a 10.8–30 V DC power supply using the A-coded M12 connec-
tor and cable P/N T128391ACC.
• Connect the camera to a PoE unit using the X-coded M12 connector and cable P/N
T128390ACC.
12.2 Connecting the camera to the network
The camera is set up on an existing network, and an IP address is assigned from the
DHCP server. The MAC address can be found on a label on the side of the camera. See
the figure below.
To detect the camera system on the network, use the FLIR IP Config software. Y