Delta Measurement Tool - FLIR AX8 User Manual

Camera web server interface
To add a box measurement tool, follow this procedure:
1. On the upper toolbar, click the Box measurement icon
the image, labeled with a number and including a hot spot and a cold spot. The box
tool is also displayed in the Measurements & alarms section.
2. To move the box, click inside the box in the image and drag the box to the desired
location.
3. To resize the box, click the border of the box in the image and drag the border to the
desired location.
4. To configure settings for the box, do the following:
4.1. In the Measurements & alarms section, click the Box icon
dialog box where you can configure the settings.
4.2. To set local parameters for the box, see section 14.3.6.3
4.3. To select what measurement results to display, use the check boxes Measure
box max, Measure box min, and Measure box avg.
4.4. To display how much of the box is covered by an isotherm, select the check
box Isotherm coverage (%). This setting is only applicable if you have selected
a color alarm (isotherm). For more information, see section 14.3.8.3
4.5. To show/hide the maximum and minimum markers (hot spot and cold spot) in
the overlay graphics, select/deselect the check box Show max & min markers.
5. To associate an alarm with the box, see section 14.3.7
6. To remove the box, click the Delete icon
alarms menu.

14.3.5.4 Delta measurement tool

The delta measurement tool is used to calculate the difference between two measure-
ment results. It is possible to set up a difference calculation between results from added
spots and boxes, as well as a fixed temperature.
. This displays a box on
. This displays a
next to the tool in the Measurements &