Regional Settings; Network Settings - FLIR AX8 User Manual

Camera web server interface

14.4.2 Regional settings

14.4.2.1 General
It is possible to change the regional settings, such as the temperature and distance units,
date and time settings, and time zone.
14.4.2.2 Procedure
To manage the regional settings, follow this procedure:
1. Click on Regional settings. This displays the regional settings.
2. To change the temperature unit, select Celsius (C) or Fahrenheit (F) from the Temper-
ature unit list box.
3. To change the distance unit, select Meter (m) or Feet (ft) from the Distance unit list
box.
4. To apply the date and time settings from the computer, click the Set from computer
button.
5. To apply the date and time settings from an internet time server (SNTP), do the
following:
5.1. Click the Edit button. This displays a text box.
5.2. In the text box, enter the IP address of the internet time server.
5.3. Click the Apply button.
6. To change the time zone, select the correct time zone from Time zone the list box.

14.4.3 Network settings

14.4.3.1 General
It is possible to manage the network setup and to select the streaming bit rate.
Note When altering the network settings, the address of the camera might change.
Make sure your settings are correct before saving them or the camera might not be
reachable afterwards. If this occurs, you can use FLIR IP Config to locate the camera
again or reset the camera to its default settings.