Changing The Language - FLIR AX8 User Manual

FLIR IP Config
2. In the list of detected cameras, do the following:
• Right-click one camera and select Modify.
• Select one camera and click
This will display the IP Address Settings dialog box:
3. In the IP Address Settings dialog box, you can enter new values for one or more of
the following parameters:
• IP address.
• Subnet mask.
• Default gateway.
4. Click OK.
Note
• A network switch may have the spanning tree algorithm (STA) enabled. The STA
blocks all packets from a new connected port for a "forward delay" second. This for-
ward delay is usually between 15 and 45 seconds. A GigE Vision device complying
with the GigE Vision standard will attempt for only 6 seconds (±2 seconds) to get its
IP address through DHCP before using the local link address (LLA = 169.254.x.x) to
get its IP address. The DHCP process for a GigE Vision-compliant device may there-
fore fail if connected to a switch which has STA enabled. To prevent this from happen-
ing, the forward delay should be set to 4 seconds, or the STA disabled for the switch
port.
• If you change the IP address, you need to restart the camera (dependent on the cam-
era model).

16.2.3 Changing the language

Follow this procedure:
1. On the Start menu, click FLIR IP Config (Start > Programs > FLIR Systems > FLIR IP
Config).
2. On the main menu bar, click Options. This will display the Options dialog box:
3. To change the language, select a new language in the Language box.
4. Click OK.
on the toolbar.