Trip Mode (Id=11802); Autogeofencing; Autogeofencing Priority (Id=20000); Activation Timeout (Id=20003) - Teltonika FMB920 User Manual

6.7.34 Trip mode (ID=11802)

For this feature I/O ODOMETER must be enabled. If I/O ODOMETER is enabled, and mode
is set to Continuous (value 0), TRIP distance is going to be counted till the end of trip, if between
records mode is set, ODOMETER will count distance only between two records.
Minimum Maximum
value value
0 1
6.8

AutoGeofencing

6.8.1.1

AutoGeofencing priority (ID=20000)

Defines priority of trip scenario:
0 – disabled, 1 – low, 2 – high, 3 – panic
Minimum Maximum
value value
0 3
6.8.1.2

Activation Timeout (ID=20003)

Parameter represents AutoGeofencing activation timeout in seconds.
Minimum Maximum
value value
0 65535
6.8.1.3

Deactivate by (ID=20005)

Parameter defines Autogeofence deactivation source. Value 0 – for Ignition, - Power
Voltage, Digital Input 1
Minimum Maximum
value value
0 2
6.8.1.4

AutoGeofence event generating (ID=20001)

Generate event: 0 – on exiting zone , 1 – on entering zone; 2 – on both;
Minimum Maximum
value value
0 2
6.8.1.5

Radius (ID=20004)

Parameter represents radius of circle with center device coordinates after activating
AutoGeofence feature.
Minimum Maximum
value value
0 1000000
Recommended Goes with (depends on)
value
-
Recommended Goes with (depends on)
value
0
Recommended Goes with (depends on)
value
60
Recommended Goes with (depends on)
value
-
Recommended Goes with (depends on)
value
0
Recommended Goes with (depends on)
value
100
parameters
Trip (ID=11800)
parameters
parameters
AutoGeofencing priority
(ID=20000)
parameters
AutoGeofencing priority
(ID=20000)
parameters
AutoGeofencing priority
(ID=20000)
parameters
AutoGeofencing priority
(ID=20000)
Value
type
U8
Value
type
U8
Value
type
U16
Value
type
U8
Value
type
U8
Value
type
U32
78