Parameter List; System Parameters; Sleep Mode (Id=102); Sleep Timeout (Id=103) - Teltonika GH5200 User Manual

7 PARAMETER LIST

7.1

System parameters

7.1.1 Sleep Mode (ID=102)

Device has three sleep modes: GPS sleep, Deep Sleep and Online Deep Sleep mode. When
sleep is disabled (value 0) module will never enter sleep mode, in sleep mode (value 1) module
reduces level of power usage by turning GPS module to sleep, in deep sleep mode (value 2)
module turns GPS module to sleep and device is deregistered from network (note, that GH5200
do not receive SMS when in deep sleep), online Deep Sleep mode (value 3) device works as in
Deep Sleep mode, but without deregistering from GSM network. GSM part stays powered, so
this increases power consumption. In this mode, device should received/send SMS and
make/receive calls. Also not closes GPRS context, if previously opened.
Minimum Maximum
value value
0 4

7.1.2 Sleep timeout (ID=103)

Sleep timeout is time after which GH5200 goes into GPS sleep, Deep Sleep or Online Deep
Sleep if other requirements are met. Its parameter is set in minutes.
Minimum Maximum
value value
1 3000

7.1.3 Static Navigation (ID=106)

When static navigation is enabled, GH5200 filters out GPS jumps, when it is not moving.
When it is disabled, it does not make any changes to collected GPS data.
Minimum Maximum
value value
0 1

7.1.4 Saving/Sending without time synchronization (ID=107)

When this feature is enabled (value = 1), then records can be saved and sent to server
without time synchronization.
Minimum Maximum
value value
0 2

7.1.5 GNSS Source (ID=109)

This parameter sets satellite system(s), available values are:
Default value Goes with (depends on)
2 Sleep timeout (ID=103)
Default value Goes with (depends on)
10
Default value Goes with (depends on)
1
Default value Goes with (depends on)
0
63
parameters
parameters
Sleep Mode (ID=102)
parameters
parameters
Value type
Uint8
Value type
Uint8
Value type
Uint8
Value type
Uint8