Example For Configuring Svc Mpls L2Vpn - H3C SR8800 10G Mpls Configuration Manual

Reply from 100.1.1.2: bytes=56 Sequence=2 ttl=255 time=60 ms
Reply from 100.1.1.2: bytes=56 Sequence=3 ttl=255 time=10 ms
Reply from 100.1.1.2: bytes=56 Sequence=4 ttl=255 time=70 ms
Reply from 100.1.1.2: bytes=56 Sequence=5 ttl=255 time=60 ms
--- 100.1.1.2 ping statistics ---
5 packet(s) transmitted
5 packet(s) received
0.00% packet loss
round-trip min/avg/max = 10/76/180 ms

Example for configuring SVC MPLS L2VPN

Network requirements
As shown in
Establish an SVC MPLS L2VPN between CE 1 and CE 2.
Figure 51 Network diagram
Device
CE 1
PE 1
CE 2
Configuration procedure
The main steps are the following two:
Configure MPLS basic forwarding capability on the PEs and P router. This includes configuring the
•
LSR ID, enabling MPLS and LDP, and running IGP (OSPF in this example) between PE 1, the P router,
and PE 2 to establish LSPs.
Establish an SVC MPLS L2VPN connection. This includes enabling MPLS L2VPN on PE 1 and PE 2
•
and establishing an SVC connection and specifying the VC labels.
The detailed configuration procedure is as follows:
Configure CE 1.
1.
<Sysname> system-view
[Sysname] sysname CE1
[CE1] interface GigabitEthernet 4/1/1
Figure 51, the CEs are connected to PEs through GigabitEthernet interfaces.
Interface IP address
GE4/1/1 100.1.1.1/24
Loop0 192.2.2.2/32
GE4/1/2 10.1.1.1/24
GE4/1/1 100.1.1.2/24
Device Interface
P Loop0
GE4/1/1
GE4/1/2
PE 2 Loop0
GE4/1/1
209
IP address
192.4.4.4/32
10.2.2.2/24
10.1.1.2/24
192.3.3.3/32
10.2.2.1/24