H3C SR8800 10G Mpls Configuration Manual page 188

# Configure LDP VPLS instance aaa that supports the hub-spoke model, and configure the peer as
the hub.
[Spoke-PE1] vsi aaa static hub-spoke
[Spoke-PE1-vsi-aaa] pwsignal ldp
[Spoke-PE1-vsi-aaa-ldp] vsi-id 500
[Spoke-PE1-vsi-aaa-ldp] peer 3.3.3.9 hub
[Spoke-PE1-vsi-aaa-ldp] quit
[Spoke-PE1-vsi-aaa] quit
# Configure interface GigabitEthernet 3/1/2, bind VPLS instance aaa to the interface, and
specify the attached CE as a spoke-CE.
[Spoke-PE1] interface GigabitEthernet 3/1/2
[Spoke-PE1-GigabitEthernet3/1/2] l2 binding vsi aaa spoke
[Spoke-PE1-GigabitEthernet3/1/2] quit
Configure Spoke-PE 2.
3.
# Configure basic MPLS.
<Sysname> system-view
[Sysname] sysname Spoke-PE2
[Spoke-PE2] interface loopback 0
[Spoke-PE2-LoopBack0] ip address 2.2.2.9 32
[Spoke-PE2-LoopBack0] quit
[Spoke-PE2] mpls lsr-id 2.2.2.9
[Spoke-PE2] mpls
[Spoke-PE2–mpls] quit
[Spoke-PE2] mpls ldp
[Spoke-PE2–mpls-ldp] quit
# Configure basic MPLS on the interface connected to Hub-PE.
[Spoke-PE2] interface GigabitEthernet3/1/1
[Spoke-PE2-GigabitEthernet3/1/1] ip address 20.1.1.1 24
[Spoke-PE2-GigabitEthernet3/1/1] mpls
[Spoke-PE2-GigabitEthernet3/1/1] mpls ldp
[Spoke-PE2-GigabitEthernet3/1/1] quit
# Configure the remote LDP session with Hub-PE.
[Spoke-PE2] mpls ldp remote-peer 2
[Spoke-PE2-mpls-remote-2] remote-ip 3.3.3.9
[Spoke-PE2-mpls-remote-2] quit
# Enable L2VPN and MPLS L2VPN.
[Spoke-PE2] l2vpn
[Spoke-PE2-l2vpn] mpls l2vpn
[Spoke-PE2-l2vpn] quit
# Configure the LDP VPLS instance aaa that supports the hub-spoke model, and configure the peer
as the hub.
[Spoke-PE2] vsi aaa static hub-spoke
[Spoke-PE2-vsi-aaa] pwsignal ldp
[Spoke-PE2-vsi-aaa-ldp] vsi-id 500
[Spoke-PE2-vsi-aaa-ldp] peer 3.3.3.9 hub
[Spoke-PE2-vsi-aaa-ldp] quit
[Spoke-PE2-vsi-aaa] quit
177