Configuring Routing Between Mce And Pe - H3C SR8800 10G Mpls Configuration Manual

Step
1. Enter system view.
2. Enter BGP view.
3. Enter IPv6 address family
view.
4. Configure the MCE as the
EBGP peer.
5. Redistribute the IGP routes of
the VPN.

Configuring routing between MCE and PE

MCE-PE routing configuration includes these tasks:
Bind the MCE-PE interfaces to IPv6 VPN instances
•
Perform routing configurations
•
• Redistribute IPv6 VPN routes into the routing protocol running between the MCE and the PE.
NOTE:
Configurations in this section are configured on the MCE. Configurations on the PE are similar to those on
the PE in common IPv6 MPLS L3VPN network solutions (see
Configuring IPv6 static routing between MCE and PE
To configure static routing between MCE and PE:
Step
1. Enter system
view.
2. Configure
static routes
for an IPv6
VPN
instanceN/A.
3. Configure the
default
precedence
for static
routes.
Command
system-view
bgp as-number
ipv6-family
peer ipv6-address as-number
as-number
import-route protocol [ process-id
[ med med-value | route-policy
route-policy-name ] * ]
Command
system-view
ipv6 route-static ipv6-address prefix-length { interface-type
interface-number [ next-hop-address ] | next-hop-address |
vpn-instance d-vpn-instance-name nexthop-address } [ preference
preference-value ]
ipv6 route-static vpn-instance s-vpn-instance-name&<1-6>
ipv6-address prefix-length { interface-type interface-number
[ next-hop-address ] | nexthop-address [ public ] | vpn-instance
d-vpn-instance-name nexthop-address } [ preference
preference-value ]
ipv6 route-static default-preference default-preference-value
"Configuring routing between PE and
366
Remarks
N/A
N/A
N/A
Required
Optional
By default, no route redistribution
is configured.
A VPN site must advertise the IPv6
VPN network addresses it can
reach to the connected MCE.
Remarks
N/A
Required
User either
command.
Optional
60 by default
CE").