Table of Contents
Advertisement
Step
4.
Configure BC 0 and BC 1 of
the MPLS TE link in the RDM
model of the prestandard
DS-TE.
5.
Configure maximum
reservable bandwidth and
BCs of the MPLS TE link in the
MAM model of the IETF
DS-TE.
6.
Configure the BCs of the MPLS
TE link in the RDM model of
the IETF DS-TE.
Configuring CSPF
To configure CSPF:
Step
1.
Enter system view.
2.
Enter MPLS view.
3.
Enable CSPF on your router.
Configuring OSPF TE
Configure OSPF TE if the routing protocol is OSPF and a dynamic signaling protocol is used for MPLS TE
tunnel setup.
The OSPF TE extension uses Opaque Type 10 LSAs to carry TE attributes of links. Before configuring
OSPF TE, you need to enable the opaque capability of OSPF. In addition, for TE LSAs to be generated,
at least one neighbor must be in full state.
To configure OSPF TE:
Step
1.
Enter system view.
2.
Enter OSPF view.
3.
Enable the opaque LSA
capability.
4.
Enter OSPF area view.
5.
Enable MPLS TE in the OSPF
area.
Command
mpls te
max-reservable-bandwidth
bandwidth-value [ bc1
bc1-bandwidth ]
mpls te
max-reservable-bandwidth mam
bandwidth-value { bc0
bc0-bandwidth | bc1
bc1-bandwidth | bc2
bc2-bandwidth | bc3
bc3-bandwidth } *
mpls te
max-reservable-bandwidth rdm
bandwidth-value [ bc1
bc1-bandwidth ] [ bc2
bc2-bandwidth ] [ bc3
bc3-bandwidth ]
Command
system-view
mpls
mpls te cspf
Command
system-view
ospf [ process-id ]
opaque-capability enable
area area-id
mpls-te enable
61
Remarks
Optional.
0 for both BC 0 and BC 1 by
default.
In RDM model, BC 0 is the
maximum reservable bandwidth of
a link.
Optional.
By default, the maximum
bandwidth, and BC 0 through BC
3 are all 0.
Optional.
0 for BC 0 through BC 3 by default
In RDM model, BC 0 is the
maximum reservable bandwidth of
a link.
Remarks
N/A
N/A
Disabled by default
Remarks
N/A
N/A
Disabled by default
N/A
Disabled by default
Advertisement
Table of Contents
Troubleshooting
