Table of Contents
Advertisement
Step
3.
Specify the metric type to use
when no metric type is
explicitly configured for a
tunnel.
4.
Exit to system view.
5.
Enter MPLS TE tunnel interface
view.
6.
Specify the metric type to use
for path calculation of the
current tunnel.
7.
Submit current tunnel
configuration.
8.
Return to system view.
9.
Enter interface view of MPLS
TE link.
10.
Assign a TE metric to the link.
NOTE:
If you do not configure the mpls te path metric-type command in MPLS TE tunnel interface view, the metric
type specified in MPLS view takes effect.
Configuring the traffic flow type of a tunnel
To configure the traffic flow type of a tunnel:
Step
1.
Enter system view.
2.
Enter MPLS TE tunnel interface
view.
3.
Configure the traffic flow type
of the TE tunnel.
4.
Submit current tunnel
configuration.
Configuring CR-LSP backup
CR-LSP backup provides end-to-end path protection to protect the entire LSP.
Command
mpls te path metric-type { igp | te }
quit
interface tunnel tunnel-number
mpls te path metric-type { igp | te }
mpls te commit
quit
interface interface-type
interface-number
mpls te metric value
Command
system-view
interface tunnel tunnel-number
mpls te vpn-binding { acl
acl-number | vpn-instance
vpn-instance-name }
mpls te commit
77
Remarks
Optional.
TE metrics of links are used by
default.
N/A
N/A
Optional.
By default, no specific link metric
type is specified for the tunnel
interface and the one specified in
MPLS view is used.
Optional.
N/A
N/A
Optional.
If no TE metric is assigned to the
link, IGP metric is used as the TE
metric by default.
Remarks
N/A
N/A
Optional.
Traffic flow types of TE tunnels are
not restricted by default.
N/A
Advertisement
Table of Contents
Troubleshooting
