H3C SR8800 10G Mpls Configuration Manual page 107

[RouterC-POS2/1/1] mpls te max-link-bandwidth 10000
[RouterC-POS2/1/1] mpls te max-reservable-bandwidth 5000
[RouterC-POS2/1/1] quit
# Configure maximum link bandwidth and maximum reservable bandwidth on Router D.
[RouterD] interface GigabitEthernet 3/1/1
[RouterD-GigabitEthernet3/1/1] mpls te max-link-bandwidth 10000
[RouterD-GigabitEthernet3/1/1] mpls te max-reservable-bandwidth 5000
[RouterD-GigabitEthernet3/1/1] quit
Create an MPLS TE tunnel
6.
# Create an MPLS TE tunnel on Router A.
[RouterA] interface tunnel 4
[RouterA-Tunnel4] ip address 7.1.1.1 255.255.255.0
[RouterA-Tunnel4] tunnel-protocol mpls te
[RouterA-Tunnel4] destination 4.4.4.9
[RouterA-Tunnel4] mpls te tunnel-id 10
[RouterA-Tunnel4] mpls te signal-protocol rsvp-te
[RouterA-Tunnel4] mpls te bandwidth 2000
[RouterA-Tunnel4] mpls te commit
[RouterA-Tunnel4] quit
Verify the configuration
7.
Perform the display interface tunnel command on Router A. You can find that the tunnel interface
is up.
[RouterA] display interface tunnel
Tunnel4 current state: UP
Line protocol current state: UP
Description: Tunnel4 Interface
The Maximum Transmit Unit is 1500
Internet Address is 7.1.1.1/24 Primary
Encapsulation is TUNNEL, service-loopback-group ID not set
Tunnel source unknown, destination 4.4.4.9
Tunnel protocol/transport CR_LSP
Output queue : (Urgent queuing : Size/Length/Discards)
Output queue : (Protocol queuing : Size/Length/Discards)
Output queue : (FIFO queuing : Size/Length/Discards)
Last 300 seconds input:
Last 300 seconds output:
0 packets input,
0 input error
0 packets output,
0 output error
Perform the display mpls te tunnel-interface command on Router A to verify information about the
MPLS TE tunnel.
[RouterA] display mpls te tunnel-interface
Tunnel Name
Tunnel Desc
Tunnel State Desc :
Tunnel Attributes :
0 bytes/sec, 0 packets/sec
0 bytes/sec, 0 packets/sec
0 bytes
0 bytes
: Tunnel4
: Tunnel4 Interface
CR-LSP is Up
96
0/100/0
0/500/0
0/75/0