H3C SR8800 10G Mpls Configuration Manual page 284

NOTE:
For more information about RIP, see
Configuring OSPF between MCE and PE
To configure OSPF between MCE and PE:
Step
1. Enter system view.
2. Create an OSPF process for a
VPN instance and enter OSPF
view.
3. Enable the multi-VPN-instance
function of OSPF.
4. Configure the OSPF domain
ID.
5. Redistribute the VPN routes.
6. Configure a filtering policy to
filter the redistributed routes.
7. Configure the default
parameters for redistributed
routes (cost, route number,
tag, and type).
8. Create an OSPF area and
enter OSPF area view.
9. Enable OSPF on the interface
attached to the specified
network in the area.
NOTE:
For more information about OSPF, see
Configuring IS-IS between MCE and PE
To configure IS-IS between MCE and PE:
Step
1. Enter system view.
2. Create an IS-IS process for a
VPN instance and enter IS-IS
view.
Layer 3—IP Routing Configuration Guide
Command
system-view
ospf [ process-id | router-id
router-id | vpn-instance
vpn-instance-name ] *
vpn-instance-capability simple
domain-id domain-id [ secondary ]
import-route protocol [ process-id
| allow-ibgp ] [ cost cost | type
type | tag tag | route-policy
route-policy-name ] *
filter-policy { acl-number |
ip-prefix ip-prefix-name } export
[ protocol [ process-id ] ]
default { cost cost | limit limit | tag
tag | type type } *
area area-id
network ip-address wildcard-mask
Layer 3—IP Routing Configuration Guide
Command
system-view
isis [ process-id ] vpn-instance
vpn-instance-name
273
.
Remarks
N/A
N/A
Disabled by default.
Optional.
0 by default.
By default, no route of any other
routing protocol is redistributed
into OSPF.
Optional.
By default, redistributed routes are
not filtered.
Optional.
The default cost is 1, the default
maximum number of routes
redistributed per time is 1000, the
default tag is 1, and default type of
redistributed routes is Type-2.
By default, no OSPF area is
created.
By default, an interface neither
belongs to any area nor runs
OSPF.
.
Remarks
N/A
N/A