H3C SR8800 10G Mpls Configuration Manual page 379

Step
8. Enable the OSPFv3 process
on the interface.
NOTE:
For more information about OSPFv3, see
Configuring IPv6 IS-IS between MCE and PE
To configure IPv6 IS-IS between MCE and PE:
Step
1. Enter system view.
2. Create an IS-IS process
for an IPv6 VPN
instance and enter IS-IS
view.
3. Configure a network
entity title.
4. Enable the IPv6
capacity for the IS-IS
process.
5. Redistribute the VPN
routes.
6. Configure a filtering
policy to filter the
redistributed routes.
7. Return to system view.
Enter interface view.
8.
9. Enable IPv6 for the IS-IS
process on the
interface.
NOTE:
For more information about IPv6 IS-IS, see
Configuring EBGP between MCE and PE
To configure EBGP between MCE and PE:
Command
ospfv3 process-id area area-id
[ instance instance-id ]
Layer 3—IP Routing Configuration Guide
Command
system-view
isis [ process-id ] vpn-instance
vpn-instance-name
network-entity net
ipv6 enable
ipv6 import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost | [ level-1 |
level-1-2 | level-2 ] | route-policy
route-policy-name | tag tag ] *
ipv6 filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name |
route-policy route-policy-name } export
[ protocol [ process-id ] ]
quit
interface interface-type interface-number
isis ipv6 enable [ process-id ]
Layer 3—IP Routing Configuration Guide
368
Remarks
Disabled by default.
.
Remarks
N/A
Required
Not configured by default.
Disabled by default.
Optional
By default, IS-IS does not
redistribute routes of any other
routing protocol.
If you do not specify the route level
in the command, the command will
redistribute routes to the level-2
routing table by default.
Optional
By default, IPv6 IS-IS does not filter
redistributed routes.
N/A
N/A
Disabled by default.
.