Configuring Inter-As Ipv6 Vpn Option A; Configuring Inter-As Ipv6 Vpn Option C - H3C SR8800 10G Mpls Configuration Manual

Configuring inter-AS IPv6 VPN option A

Inter-AS IPv6 VPN option A applies to scenarios where the number of VPNs and that of VPN routes on
the PEs are relatively small. It is easy to implement.
To configure inter-AS IPv6 option A, you need to:
• Perform basic IPv6 MPLS L3VPN configuration on each AS.
Configure each ASBR, taking the peer ASBR PE as its CE. In other words, configure VPN instances
•
on both PEs and ASBR PEs. The VPN instances on PEs allow CEs to access the network, while those
on ASBR PEs are for access of the peer ASBR PEs.
For configuration information, see the chapter
NOTE:
In the inter-AS IPv6 VPN option A solution, for the same IPv6 VPN, the VPN targets configured on the PEs
must match those configured on the ASBR-PEs in the same AS to make sure that VPN routes sent by the PEs
(or ASBR-PEs) can be received by the ASBR-PEs (or PEs). VPN targets configured on the PEs in different
ASs do not have such requirements.

Configuring inter-AS IPv6 VPN option C

Configuring the PEs
You need to establish ordinary IBGP peer relationships between PEs and ASBR PEs in an AS and
MP-EBGP peer relationships between PEs in different ASs.
The PEs and ASBR PEs in an AS must be able to exchange labeled routes.
To configure a PE for inter-AS IPv6 VPN option C:
Step
1. Enter system view.
2. Enter BGP view.
3. Configure the ASBR PE in the
same AS as the IBGP peer.
4. Enable the PE to exchange
labeled routes with the ASBR
PE in the same AS.
5. Configure the PE of another
AS as the EBGP peer.
6. Enter BGP-VPNv6 subaddress
family view.
7. Enable the PE to exchange
BGP VPNv6 routing
information with the EBGP
peer.
"Configuring basic IPv6 MPLS
Command
system-view
bgp as-number
peer { group-name | ip-address }
as-number as-number
peer { group-name | ip-address }
label-route-capability
peer { group-name | ip-address }
as-number as-number
ipv6-family vpnv6
peer ip-address enable
361
L3VPN."
Remarks
N/A
N/A
Required
By default, the PE does not
advertise labeled routes to the IPv4
peer/peer group.
Required
N/A
Required