H3C SR8800 10G Mpls Configuration Manual page 260

Configuration prerequisites
Before you configure routing between PE and CE, complete the following tasks:
• Assigning an IP address to the CE-PE interface of the CE.
Assigning an IP address to the PE-CE interface of the PE.
•
Configuring static routing between PE and CE
To configure static routing between PE and CE:
Step
1. Enter system view.
2. Configure a static route
for a VPN instance.
NOTE:
For information about static routing, see
Configuring RIP between PE and CE
A RIP process belongs to the public network or a single VPN instance. If you create a RIP process without
binding it to a VPN instance, the process belongs to the public network.
To configure RIP between PE and CE:
Step
1. Enter system view.
2. Create a RIP process for a
VPN instance and enter RIP
view.
3. Enable RIP on the interface
attached to the specified
network.
NOTE:
For more information about RIP, see
Command
system-view
•
ip route-static dest-address { mask |
mask-length } { gateway-address |
interface-type interface-number
[ gateway-address ] | vpn-instance
d-vpn-instance-name gateway-address }
[ preference preference-value ] [ tag
tag-value ] [ description description-text ]
•
ip route-static vpn-instance
s-vpn-instance-name&<1-5> dest-address
{ mask | mask-length } { gateway-address
[ public ] | interface-type interface-number
[ gateway-address ] | vpn-instance
d-vpn-instance-name gateway-address }
[ preference preference-value ] [ tag
tag-value ] [ description description-text ]
Layer 3—IP Routing Configuration Guide
Command
system-view
rip [ process-id ] vpn-instance
vpn-instance-name
network network-address
Layer 3 IP Routing Configuration Guide
—
249
Remarks
N/A
Use either command.
Perform this configuration
on PEs. On CEs, configure
normal static routes.
.
Remarks
N/A
Perform this configuration on PEs.
On CEs, create a normal RIP
process.
By default, RIP is disabled on an
interface.
.