H3C SR8800 10G Mpls Configuration Manual page 374

Step
3. Configure the default
precedence for IPv6 static
routes.
Configuring RIPng between MCE and VPN site
A RIPng process belongs to the public network or a single IPv6 VPN instance. If you create a RIPng
process without binding it to an IPv6 VPN instance, the process belongs to the public network. By
configuring RIPng process-to-IPv6 VPN instance bindings on a MCE, you allow routes of different VPNs
to be exchanged between the MCE and the sites through different RIPng processes, ensuring the
separation and security of IPv6 VPN routes.
To configure RIPng between MCE and VPN site:
Step
1. Enter system view.
2. Create a RIPng process for a
VPN instance and enter RIPng
view.
3. Redistribute remote site routes
advertised by the PE.
4. Configure the default cost
value for the redistributed
routes.
5. Return to system view.
6. Enter interface view.
7. Enable RIPng on the interface.
NOTE:
For more information about RIPng, see
Configuring OSPFv3 between MCE and VPN site
An OSPFv3 process belongs to the public network or a single IPv6 VPN instance. If you create an
OSPFv3 process without binding it to an IPv6 VPN instance, the process belongs to the public network.
By configuring OSPFv3 process-to-IPv6 VPN instance bindings on a MCE, you allow routes of different
IPv6 VPNs to be exchanged between the MCE and the sites through different OSPFv3 processes,
ensuring the separation and security of IPv6 VPN routes.
To configure OSPFv3 between MCE and VPN site:
Command
ipv6 route-static vpn-instance
s-vpn-instance-name&<1-6> ipv6-address
prefix-length { interface-type interface-number
[ next-hop-address ] | nexthop-address [ public ]
| vpn-instance d-vpn-instance-name
nexthop-address } [ preference
preference-value ]
ipv6 route-static default-preference
default-preference-value
Command
system-view
ripng [ process-id ] vpn-instance
vpn-instance-name
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost |
route-policy route-policy-name ] *
default cost value
quit
interface interface-type
interface-number
ripng process-id enable
Layer 3—IP Routing Configuration Guide
363
Remarks
configure normal
static routes.
Optional
60 by default
Remarks
N/A
Perform this configuration on the
MCE. On a VPN site, configure
normal RIPng.
By default, no route of any other
routing protocol is redistributed
into RIPng.
Optional
0 by default
N/A
N/A
Disabled by default
.