H3C SR8800 10G Mpls Configuration Manual page 193

[NPE1-vsi-aaa-ldp] peer 4.4.4.4
[NPE1-vsi-aaa-ldp] quit
[NPE1-vsi-aaa] quit
The configuration procedure on NPE 2 is similar to that on NPE 1. (Details not shown)
Configure NPE 3.
4.
# Configure basic MPLS.
<Sysname> system-view
[Sysname] sysname NPE3
[NPE3] interface loopback 0
[NPE3-LoopBack0] ip address 4.4.4.4 32
[NPE3-LoopBack0] quit
[NPE3] mpls lsr-id 4.4.4.4
[NPE3] mpls
[NPE3–mpls] quit
[NPE3] mpls ldp
[NPE3–mpls-ldp] quit
# Configure an IP address for the interface connected to NPE 1, and then enable MPLS and MPLS
LDP.
[NPE3]interface GigabitEthernet 3/1/5
[NPE3-GigabitEthernet3/1/5] ip address 15.1.1.2 255.255.255.0
[NPE3-GigabitEthernet3/1/5]mpls
[NPE3-GigabitEthernet3/1/5]mpls ldp
[NPE3-GigabitEthernet3/1/5]quit
# Configure an IP address for the interface connected to NPE 2, and then enable MPLS and MPLS
LDP.
[NPE3]interface GigabitEthernet 3/1/6
[NPE3-GigabitEthernet3/1/6] ip address 16.1.1.2 255.255.255.0
[NPE3-GigabitEthernet3/1/6]mpls
[NPE3-GigabitEthernet3/1/61]mpls ldp
[NPE3-GigabitEthernet3/1/6]quit
# Configure the remote LDP session.
[NPE3] mpls ldp remote-peer 1
[NPE3-mpls-remote-1] remote-ip 2.2.2.2
[NPE3-mpls-remote-1] quit
[NPE3] mpls ldp remote-peer 2
[NPE3-mpls-remote-2] remote-ip 3.3.3.3
[NPE3-mpls-remote-2] quit
# Enable L2VPN and MPLS L2VPN.
[NPE3] l2vpn
[NPE3-l2vpn] mpls l2vpn
[NPE3-l2vpn] quit
# Configure the VPLS instance aaa that uses LDP signaling
[NPE3] vsi aaa static
[NPE3-vsi-aaa] pwsignal ldp
[NPE3-vsi-aaa-ldp] vsi-id 500
[NPE3-vsi-aaa-ldp] peer 2.2.2.2
[NPE3-vsi-aaa-ldp] peer 3.3.3.3
182