H3C SR8800 10G Mpls Configuration Manual page 185

[NPE1] mpls lsr-id 2.2.2.9
[NPE1] mpls
[NPE1–mpls] quit
[NPE1] mpls ldp
[NPE1–mpls-ldp] quit
# Configure basic MPLS on the interface connected to UPE.
[NPE1] interface GigabitEthernet3/1/1
[NPE1-GigabitEthernet3/1/1] ip address 10.1.1.2 24
[NPE1-GigabitEthernet3/1/1] mpls
[NPE1-GigabitEthernet3/1/1] mpls ldp
[NPE1-GigabitEthernet3/1/1] quit
# Configure basic MPLS on the interface connected to NPE 3.
[NPE1] interface GigabitEthernet3/1/2
[NPE1-GigabitEthernet3/1/2] ip address 11.1.1.1 24
[NPE1-GigabitEthernet3/1/2] mpls
[NPE1-GigabitEthernet3/1/2] mpls ldp
[NPE1-GigabitEthernet3/1/2] quit
# Configure the remote LDP session with UPE.
[NPE1] mpls ldp remote-peer 2
[NPE1-mpls-remote-2] remote-ip 1.1.1.9
[NPE1-mpls-remote-2] quit
# Configure the remote LDP session with NPE 3.
[NPE1] mpls ldp remote-peer 3
[NPE1-mpls-remote-3] remote-ip 3.3.3.9
[NPE1-mpls-remote-3] quit
# Enable L2VPN and MPLS L2VPN.
[NPE1] l2vpn
[NPE1-l2vpn] mpls l2vpn
[NPE1-l2vpn] quit
# Configure the VPLS instance aaa that uses LDP signaling.
[NPE1] vsi aaa static
[NPE1-vsi-aaa] pwsignal ldp
[NPE1-vsi-aaa-ldp] vsi-id 500
[NPE1-vsi-aaa-ldp] peer 1.1.1.9 upe
[NPE1-vsi-aaa-ldp] peer 3.3.3.9
[NPE1-vsi-aaa-ldp] quit
[NPE1-vsi-aaa] quit
Configure NPE 3.
4.
# Configure basic MPLS.
<Sysname> system-view
[Sysname] sysname NPE3
[NPE3] interface loopback 0
[NPE3-LoopBack0] ip address 3.3.3.9 32
[NPE3-LoopBack0] quit
[NPE3] mpls lsr-id 3.3.3.9
[NPE3] mpls
[NPE3–mpls] quit
174