H3C SR8800 10G Mpls Configuration Manual page 378

Configuring RIPng between MCE and PE
To configure RIPng between MCE and PE:
Step
1. Enter system view.
2. Create a RIPng process
for an IPv6 VPN
instance and enter
RIPng view.
3. Redistribute the VPN
routes.
4. Configure the default
cost value for the
redistributed routes.
5. Return to system view.
6. Enter interface view.
7. Enable the RIPng
process on the
interface.
NOTE:
For more information about RIPng, see
Configuring OSPFv3 between MCE and PE
To configure OSPFv3 between MCE and PE:
Step
1. Enter system view.
2. Create an OSPFv3 process for
an IPv6 VPN instance and
enter OSPFv3 view.
3. Set the router ID.
4. Redistribute the VPN routes.
5. Configure a filtering policy to
filter the redistributed routes.
6. Return to system view.
7. Enter interface view.
Command
system-view
ripng [ process-id ] vpn-instance
vpn-instance-name
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost | route-policy
route-policy-name ] *
default cost value
quit
interface interface-type interface-number
ripng process-id enable
Layer 3—IP Routing Configuration Guide
Command
system-view
ospfv3 [ process-id ] vpn-instance
vpn-instance-name
router-id router-id
import-route protocol [ process-id
| allow-ibgp ] [ cost value |
route-policy route-policy-name |
type type ] *
filter-policy { acl6-number |
ipv6-prefix ipv6-prefix-name }
export [ bgp4+ | direct | isisv6
process-id | ospfv3 process-id |
ripng process-id | static ]
quit
interface interface-type
interface-number
367
Remarks
N/A
Required
By default, no route of any
other routing protocol is
redistributed into RIPng.
Optional
0 by default
N/A
N/A
Disabled by default.
.
Remarks
N/A
Required
Required
By default, no route of any other
routing protocol is redistributed
into OSPFv3.
Optional
By default, redistributed routes are
not filtered.
N/A
N/A