H3C SR8800 10G Mpls Configuration Manual page 367

NOTE:
For information about IPv6 static routing, see
Configuring RIPng between PE and CE
A RIPng process belongs to the public network or a single VPN instance. If you create a RIPng process
without binding it to a VPN instance, the process belongs to the public network.
To configure RIPng between PE and CE:
Step
1. Enter system view.
2. Create a RIPng process for a
VPN instance and enter RIPng
view.
3. Return to system view.
4. Enter interface view.
5. Enable RIPng on the interface.
NOTE:
For more information about RIPng, see
Configuring OSPFv3 between PE and CE
An OSPFv3 process belongs to the public network or a single VPN instance. If you create an OSPF
process without binding it to a VPN instance, the process belongs to the public network.
To configure OSPFv3 between PE and CE:
Step
1. Enter system view.
2. Create an OSPFv3 process for
a VPN instance and enter the
OSPFv3 view.
3. Set the router ID.
4. Return to system view.
5. Enter interface view.
6. Enable OSPFv3 on the
interface.
NOTE:
• Deleting a VPN instance will delete all related OSPFv3 processes at the same time.
For more information about OSPFv3, see
•
Layer 3—IP Routing Configuration Guide
Command
system-view
ripng [ process-id ] vpn-instance
vpn-instance-name
quit
interface interface-type
interface-number
ripng process-id enable
Layer 3—IP Routing Configuration Guide
Command
system-view
ospfv3 [ process-id ] vpn-instance
vpn-instance-name
router-id router-id
quit
interface interface-type
interface-number
ospfv3 process-id area area-id
[ instance instance-id ]
Layer 3—IP Routing Configuration Guide
356
.
Remarks
N/A
Perform this configuration on PEs.
On CEs, create a normal RIPng
process.
N/A
N/A
By default, RIPng is disabled on an
interface.
.
Remarks
N/A
Perform this configuration on PEs.
On CEs, create a normal OSPF
process.
Required
N/A
N/A
By default, OSPFv3 is disabled on
an interface.
Perform this configuration on PEs.
.