Configuring Hub-Spoke Vpls - H3C SR8800 10G Mpls Configuration Manual

[NPE3] mpls ldp
[NPE3–mpls-ldp] quit
# Configure basic MPLS on the interface connected to NPE 1.
[NPE3] interface GigabitEthernet3/1/1
[NPE3-GigabitEthernet3/1/1] ip address 11.1.1.2 24
[NPE3-GigabitEthernet3/1/1] mpls
[NPE3-GigabitEthernet3/1/1] mpls ldp
[NPE3-GigabitEthernet3/1/1] quit
# Configure the remote LDP session.
[NPE3] mpls ldp remote-peer 1
[NPE3-mpls-remote-1] remote-ip 2.2.2.9
[NPE3-mpls-remote-1] quit
# Enable L2VPN and MPLS L2VPN.
[NPE3] l2vpn
[NPE3-l2vpn] mpls l2vpn
[NPE3-l2vpn] quit
# Configure the VPLS instance aaa that uses LDP signaling.
[NPE3] vsi aaa static
[NPE3-vsi-aaa] pwsignal ldp
[NPE3-vsi-aaa-ldp] vsi-id 500
[NPE3-vsi-aaa-ldp] peer 2.2.2.9
[NPE3-vsi-aaa-ldp] quit
[NPE3-vsi-aaa] quit
# Configure interface GigabitEthernet 3/1/2 and bind VPLS instance aaa to the interface.
[NPE3] interface GigabitEthernet 3/1/2
[NPE3-GigabitEthernet3/1/2] l2 binding vsi aaa
[NPE3-GigabitEthernet3/1/2] quit
After completing previous configurations, issue the display vpls connection command on the PEs. You will
see that a PW connection in up state has been established.

Configuring hub-spoke VPLS

Network requirements
Create a PW between Spoke-PE 1 and Hub-PE and another PW between Spoke-PE 2 and Hub-PE.
Create VPLS instance aaa and configure it to support hub-spoke networking.
175