H3C SR8800 10G Mpls Configuration Manual page 375

Step
1. Enter system view.
2. Create an OSPFv3 process for
a VPN instance and enter
OSPFv3 view.
3. Set the router ID.
4. Redistribute remote site routes
advertised by the PE..
5. Return to system view.
6. Enter interface view.
7. Enable OSPFv3 on the
interface.
NOTE:
Deleting a VPN instance will delete all related OSPFv3 processes at the same time.
•
For more information about OSPFv3, see
•
Configuring IPv6 IS-IS between MCE and VPN site
An IPv6 IS-IS process belongs to the public network or a single IPv6 VPN instance. If you create an IPv6
IS-IS process without binding it to an IPv6 VPN instance, the process belongs to the public network.
By configuring IPv6 IS-IS process-to-IPv6 VPN instance bindings on a MCE, you allow routes of different
IPv6 VPNs to be exchanged between the MCE and the sites through different IPv6 IS-IS processes,
ensuring the separation and security of IPv6 VPN routes.
To configure IPv6 IS-IS between MCE and VPN site:
Step
1. Enter system view.
2. Create an IPv6 IS-IS process
for a VPN instance and enter
IS-IS view.
3. Configure a network entity
title for the IS-IS process.
4. Enable the IPv6 capacity for
the IPv6 IS-IS process.
5. Redistribute remote site routes
advertised by the PE.
Command
system-view
ospfv3 [ process-id ] vpn-instance
vpn-instance-name
router-id router-id
import-route protocol [ process-id
| allow-ibgp ] [ cost value |
route-policy route-policy-name |
type type ] *
quit
interface interface-type
interface-number
ospfv3 process-id area area-id
[ instance instance-id ]
Layer 3—IP Routing Configuration Guide
Command
system-view
isis [ process-id ] vpn-instance
vpn-instance-name
network-entity net
ipv6 enable
ipv6 import-route protocol
[ process-id ] [ allow-ibgp ] [ cost
cost | [ level-1 | level-1-2 |
level-2 ] | route-policy
route-policy-name | tag tag ] *
364
Remarks
N/A
Perform this configuration on the
MCE. On a VPN site, configure
normal OSPFv3.
Required
By default, no route of any other
routing protocol is redistributed
into OSPFv3.
N/A
N/A
By default, OSPFv3 is disabled on
an interface.
.
Remarks
N/A
Perform this configuration on the
MCE. On a VPN site, configure
normal IPv6 IS-IS.
Not configured by default
Disabled by default
Optional
By default, no routes from any
other routing protocol are
redistributed to IPv6 IS-IS.
If you do not specify the route level
in the command, redistributed
routes are added to the level-2
routing table by default.