H3C SR8800 10G Mpls Configuration Manual page 283

Bind the MCE-PE interfaces to VPN instances
•
• Perform route configurations
Redistribute VPN routes into the routing protocol running between the MCE and the PE.
•
NOTE:
Configurations in this section are made on the MCE. Configurations on the PE are similar to those on the
PE in common MPLS L3VPN network solutions (see
Configuring static routing between MCE and PE
To configure static routing between MCE and PE:
Step
1. Enter system view.
2. Configure a static route
for a VPN instance.
3. Configure the default
precedence for static
routes.
Configuring RIP between MCE and PE
To configure RIP between MCE and PE:
Step
1. Enter system view.
2. Create a RIP process for
a VPN instance and
enter RIP view.
3. Enable RIP on the
interface attached to
the specified network.
4. Redistribute the VPN
routes.
5. Configure the default
cost value for the
redistributed routes.
"Configuring routing between PE and
Command
system-view
•
ip route-static dest-address { mask | mask-length }
{ gateway-address | interface-type interface-number
[ gateway-address ] | vpn-instance
d-vpn-instance-name gateway-address } [ preference
preference-value ] [ tag tag-value ] [ description
description-text ]
•
ip route-static vpn-instance
s-vpn-instance-name&<1-6> dest-address { mask |
mask-length } { gateway-address [ public ] |
interface-type interface-number [ gateway-address ]
| vpn-instance d-vpn-instance-name
gateway-address } [ preference preference-value ]
[ tag tag-value ] [ description description-text ]
ip route-static default-preference
default-preference-value
Command
system-view
rip [ process-id ] vpn-instance
vpn-instance-name
network network-address
import-route protocol [ process-id ]
[ allow-ibgp ] [ cost cost | route-policy
route-policy-name | tag tag ] *
default cost value
272
CE").
Remarks
N/A
Use either
command.
Optional.
60 by default.
Remarks
N/A
N/A
By default, RIP is disabled on
an interface.
By default, no route of any
other routing protocol is
redistributed into RIP.
Optional.
0 by default.