Thermador PRL304EG Service Manual page 24

Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
6. Make note of which way the burner support rails are placed on the
range chassis before removing, so you can re-install in the correct
position in relation to the jet holder assemblies and gas tubes.
Sharp Component – Gloves Recommended
The burner support rail has sharp edges. Avoid injury by using gloves
when removing or installing the burner support rail.
Gas Leaks
With electrical power off, carefully check for gas leaks at each gas
component that was removed, replaced, or otherwise serviced using a
gas leak detector or bubble test.
7. Using a large flat-blade screwdriver, push one side of the burner
support rail to the other side of the chassis, until the 2 prongs
come out from their slots on the chassis (see Figure 36). Then
remove burner support rail with the two jet holder assemblies
attached (see Figure 37).
58300000156573_ARA_EN_B
Figure 36: Removing Burner Support Rail from Range Chassis
Figure 37: Burner Support Rail with Jet Holder Assembly Attached
Page 25 of 119