Kick Panel Removal And Replacement; Before Returning Appliance To Service - Thermador PRL304EG Service Manual

Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
Figure 241: Screws on Bracket
Figure 242: Oven Gasket and Bracket
1 Gasket
2 Bracket
58300000156573_ARA_EN_B

4.7.11 Kick Panel Removal and Replacement

Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 21.
2. Remove both oven doors (see Oven Door Removal, Installation,
page 88).
3. Remove and retain the screws from the kick panel (see
Figure 243), and then lift the kick panel off the range chassis.
Figure 243: Typical Kick Panel
1 Location of screws (2)
NOTE: The wiring diagram for the range is located on the back
side of the kick panel (see Wiring Diagram, page 5).
5

BEFORE RETURNING APPLIANCE TO SERVICE

After you have finished all testing and servicing, always do the
following before returning the appliance to service:
■ Carefully check for gas leaks at each gas component that was
removed, replaced, or otherwise serviced using a gas leak
detector or bubble test.
■ Make sure all electrical connections are correct and secure.
■ Make sure all safety grounds (internal and external) are correctly
and securely connected.
Page 118 of 119