Thermador PRL304EG Service Manual page 100

Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
Figure 202: HSI with Screw Shown
Figure 203: Small Bracket on HSI
6. Now remove the HSI by gently pulling its harness and wire
connector out (towards you) through the burner box.
7. Replace the HSI if needed.
NOTE: When installing the HSI onto the burner box, make sure
the small bracket is secured onto the HSI as shown in Figure 204.
The screw goes through the holes on both the HSI and the small
bracket, fastening them both onto the burner box.
58300000156573_ARA_EN_B
Figure 204: Small Bracket – Shown Removed from HSI (Left), and
Position when Attached to HSI (Right)
NOTE: When installing the HSI, feed the harness with wire
connector through the portal at the back of the range, as shown in
Figure 205.
Figure 205: Portal for HSI Harness with Wire Connector
Page 101 of 119