Replacing The Bake Burner Orifice Assembly - Large Oven - Thermador PRL304EG Service Manual

Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
4.7.6.4 Replacing the Bake Burner Orifice Assembly – Large
Oven
NOTE: When replacing the orifice assembly (orifice and elbow
connector) or the bracket that retains the orifice assembly, you do not
have to remove the bake burner box from the cavity.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
Figure 210: Frontal View of Burner Box (Shown Removed from
Cavity for Reasons of Clarity)
1 Screw locations (2) that attach to orifice assembly
bracket (screws are removed and installed from
inside of the burner box, and the bracket is mounted
onto the front of the burner box).
2 Portal for aligning orifice assembly and bake burner
3 Bracket (underneath burner box)
4 Receptacle on bracket for (green) electrode wire
58300000156573_ARA_EN_B
1. Perform all steps in Replacing the Bake Burner – Large Oven,
page 97.
2. From the back of the range remove the crossmember panel
(see Crossmember Cover Removal and Replacement, page 75).
3. From inside the burner box, remove and retain the two bracket
screws (see Figure 210 and Figure 211).
4. When the bracket screws are removed, the bracket with elbow
connector and orifice attached should drop and be accessible at
the front side of the burner box (see Figure 211).
Figure 211: Bracket with Orifice Assembly
1 Orifice
2 Elbow connector
3 Location of screws (2) on bracket
NOTE: Although you should be able to access and remove the
bracket and orifice assembly without removing the bake burner
box, if you lift the burner box out of the cavity, be careful not to
damage the surrounding insulation (see Figure 212, page 105).
Page 104 of 119