Bake Burner Solenoid Removal And Replacement - Under Maintop - Thermador PRL304EG Service Manual

Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
4.5.16 Bake Burner Solenoid Removal and Replacement – Under
Maintop
Access for the bake burner solenoid is under the maintop for all
36-inch and 30-inch models, or at the back of the range for all 48-inch
models (see Bake Burner Solenoid Removal and Replacement –
Back of Range, page 82).
For the procedure for replacing the XLO burner solenoids, see
Solenoid Valve for XLO Burner - Removal and Replacement page 42.
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
Figure 109: Solenoid for Bake Burner and Fittings – Under the Maintop
1. Follow all safety precautions and steps in Preparing the Range for
Servicing, page 21.
2. Follow all steps in Accessing Components under the Maintop,
page 21.
58300000156573_ARA_EN_B
3. If obstructing access to the solenoid, remove the burner support
rail (with jet holder assemblies attached) by following the steps in
the Removing the Burner Support Rail procedure, page 24.
4. At the solenoid valve outlet, use a wrench to remove and retain
the 9/16th inch compression nut and the sleeve from the 3/8th
inch diameter gas flex tube (see Figure 110).
5. At the solenoid valve inlet, use a wrench to secure the solenoid
hex nut, while you simultaneously use another wrench to rotate
the hex nut on the reducer bushing until it is detached from the
solenoid (see Figure 110).
6. Replace the solenoid if needed.
NOTE: Use pipe sealant on pipe threads only.
Never use pipe sealant on flair connections or pressure fittings.
Gas Leaks
With electrical power off, carefully check for gas leaks at each gas
component that was removed, replaced, or otherwise serviced using a
gas leak detector or bubble test.
Page 58 of 119