Bi-Metal Gas Valve Removal And Replacement - Back Of Range - Thermador PRL304EG Service Manual

Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
Figure 161: Solenoid Valve and Fittings for Bake Burner – at Back of
Range
1 Gas flex tube
2 Compression nut
3 Sleeve
4 Solenoid valve outlet (to gas flex tube / bake burner)
5 Solenoid valve
6 Solenoid valve inlet (from manifold arm)
Gas Leaks
With electrical power off, carefully check for gas leaks at each gas
component that was removed, replaced, or otherwise serviced using a
gas leak detector or bubble test.
4.6.11 Bi-Metal Gas Valve Removal and Replacement – Back of
Range
There is a dedicated bi-metal gas valve for each individual broil
burner. For 48-inch ranges, the bi-metal gas valves are located and
accessible at the back of the range. For 30-inch and 36-inch ranges,
the bi-metal gas valves are located under the maintop (see Bi-Metal
Gas Valve Removal and Replacement – Under Maintop, page 56).
58300000156573_ARA_EN_B
Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
Figure 162: Typical Bi-Metal Gas Valves
Figure 163: Bi-Metal Gas Valve and Connections
1 Spade wire connectors (2)
2 Bi-metal gas valve
3 Screws (2) that hold bi-metal valve to range chassis
4 Compression nut on gas tube at inlet
5 Compression nut on gas tube at outlet
Page 83 of 119