Broil Burner Removal And Replacement - Thermador PRL304EG Service Manual

Service Manual for Thermador Pro Grand LP Gas Ranges, Models: PRL304EG, PRL364EDG, PRL364ELG, PRL366EG, PRL484ECG, PRL486EDG, PRL486EDPG, PRL484ELG
Figure 185: HSI on HSI Retaining Bracket (Shown Attached to Broil
Burner)
1 HSI retaining bracket
2 Screw (2) and nut with lock washer (2) securing HSI
onto HSI retaining bracket
3 Nut with lock washer (2) securing HSI retaining
bracket onto broil burner
3. From inside the range, slowly and carefully pull the HSI outward
(towards you) as the two wires with spade connectors pass
through the receptacle and insulation at the back of the range.
4. Replace the HSI if necessary.
58300000156573_ARA_EN_B
4.7.5.2

Broil Burner Removal and Replacement

Be sure to check QuickFinder for relevant information, documentation,
and the correct part number when replacing this component.
Figure 186: Broil Burner Assembly
1 Broil Burner
2 Venturi tube
3 Orifice holder bracket
4 Elbow connector with orifice attached
1. Follow all steps in Broil Burner Components – Removal and
Replacement, page 93.
2. From the back of the range, use an adjustable wrench to detach
the compression nuts from the elbow connector and bi-metal valve
(see Figure 187, page 96), and then remove the gas tube.
3. From the back of the range, remove and retain the screws on the
bracket located at the receptacle for the broil burner, and then
remove the bracket (see Figure 188 and Figure 189)
Page 95 of 119